Choosing The Right Type Of Metal Fasteners

Metal fasteners come in all shapes and sizes. The most common form would be the screw. Now if you are going to use screws to attach your metal to a surface you need to understand the different types of screws first. This is a common problem for a lot of people because the choices are vast and they have no idea which type they should choose for the job at hand. First off you should always go with the screws that are designed for metal. They are easy to pick out because they do not have as sharp a point as wood screws do. Wood screws are pointed to a large extent so they can be easily stuck in the wood and will stay while they are being put in. You can not do this with metal screws as their point is far more blunt.
Metal screws are used for the purpose of attaching metal to other surfaces, including more metal. The end is blunt and it is not meant to just starting turning it to get it in. If you are using metal screws then you should always take the time to drill a pilot hole in the metal and then start inserting the screw. If you do not use the pilot hole method then you will take the chance on stripping the head and rendering the head of the screw unusable. The pilot hole acts as a guide to allow the screw to move in and attach to what is on the other side without a problem. You could also cause yourself some serious injury if you do not use the pilot holes as the screw could slip and stab you in the hand or even ruin the metal that you are trying to attach.

The other factor that you should consider is the type of screw head and the quality of the screw itself. If you buy the flat head screws then you are asking for trouble in many cases. The flat heads have a bad habit of stripping or missing and you will end up with a lot of problems and time wasted getting the screw in the area where you want it. Also the quality of the screw is important. If the screw is poor in quality then you will have an issue where you are stripping a bunch of screw heads because the metal is too soft. This can cause a lot of wasted time and the bits that you are using to pushing the screws in will take the blunt of the trauma.

Using these guidelines, you will surely have less of a hard time.

More from this author at: industrial-magazine.com

Article Source: http://www.thearticleinsiders.com